Operation of the satellite system
RX140SAT II
108
• To set the SAT cable retraction speed turn the joystick to the left until the desired speed is reached.
• To stop the feeder unit, press the right joystick button (stop button) or move the joystick into the opposite direction very shortly.
• To disable the SAT cruise control, press
again.
OR
• Turn joystick in the opposite direction.
Setting the maximum feeder speed for cruise control operation(RX140SAT II)
NOTE!
Set the feeder speed and direction by turning the left joystick. The maximum feeder speed (= 100%) is reached it the left joystick
is turned until it cannot go any further.
You can set the maximum feeder speed for cruise control operation.
• Open the
menu on the right hand side of the user interface.
• To activate / disable the maximum feeder speed press
.
• Tap on the Ƃeld on the left next to the button.
An input Ƃeld is displayed.
• Enter the maximum feeder speed in percent.
• To conƂrm the input and return to the previous ment press
.
• To cancel the input and return to the previous menu press
.
NOTE!
If you have set the feeder feed to, e.g. max. 50%, the feeder speed will always reach the 50% of the maximum possible feeder
speed, even if you turn the joystick until it can get no further.
Localization of RX140SAT II
The RX140SATII crawler has a localization transmitter integrated in the crawler. The localization can be activated in the crawler menu.
NOTE!
On the status monitor the active localization transmitter is displayed (SAT crawler or SAT camera).
If at least one of the two localization transmitters are active, the transmitter symbol at the bottom edge of the status monitor lights
up (
).
To Next Page
Loading...
Need help?
General
