Performing the inspection
Light control
98
Light control
Light ring (RCX90)
You have the opportunity to adjust the following settings:
– High beam
– Low beam
– Auto light
These functions are only available with the RCX90 camera head.
With an active auto light function the camera head switches automatically between high and low beam when the camera head moves +/- 5
degrees (default value) upwards or downwards.
As soon as this threshold (default position +/- 5 degrees upwards and downwards) is exceeded the camera head automatically switches from
high beam to low beam. As soon as the camera head moves back into the above mentioned range the camera head automatically switches from
low beam to high beam.
NOTE!
The current camera settings are saved when shutting down the system.
After restarting the control panel the previous settings are active.
If you do not have the latest software version running on your control panel, only the auto light function with the default value of
+/- 5 degrees is available for the switch between high and low beam.
• To open the menu for the light control of the light ring press in the main screen.
The light control menu is displayed.
To Next Page
Loading...
Need help?
General
