Initial set-up
Switching off the DCX5000
33
Emergency-Off
NOTE!
When shutting down the system with the emergency-off switch it is possible that unsaved data will be lost.
By pressing the emergency-off switch only the power circuit of the CCUI is interrupted. The DCX5000 continues to be in operation.
• Press the EMERGENCY-OFF switch.
The power supply is interrupted. The DCX5000 continues to be in operation.
• For restarting the system, turn the EMERGENCY-OFF switch to the right.
• Press the ON/OFF button.
The system boots.
When operating the DCX5000 with a RMX200, RLX200 or ERMX perform the following steps after the emergency-OFF:
– complete reboot of the CCU1 and RMX200 (RMX200 disconnect it from the mains - Switch off-/switch on at the E-Box of the RMX,
RLX, ERMX)
– Shutdown of the CCU1 over the DCX5000 user interface
To Next Page
Loading...
Need help?
General
