EST EST3X - Page 204

Chapter 7: Service and troubleshooting
194 EST3X Technical Reference Manual
Address
Label Source Description
0695
Inhibit Normal Flash
Bypassed Datacard1
3-SSDC
3-SSDC1
3-SDDC
3-SDDC1
Inhibition of device LED flashing has been
bypassed. Device LEDs will flash according
to state
Note: Applies to DH and DS nonmapping
devices.
0696
Inhibit Normal Flash
Bypassed Datacard2
3-SSDC
3-SSDC1
3-SDDC
3-SDDC1
Inhibition of device LED flashing has been
bypassed. Device LEDs will flash according
to state
Note: Applies to DH and DS nonmapping
devices.
[1] For R-Series annunciator local trouble pseudo points, see Table 53 and Table 54.
Table 53: R-Series annunciator local trouble pseudo points
Address
[1] Label Annunciator Description
xx90
Annunciator
Communications
RLCD, RLCD-C,
RLED-C, RGCI
A communication fault occurred between
the panel and an R-Series annunciator
xx91
Annunciator RAM
Supervision
RLCD, RLCD-C,
RLED-C, RGCI
An R-Series annunciator RAM fault was
detected
xx92
Annunciator CH1
Communications
RLCD, RLCD-C,
RLED-C, RGCI
N/A
xx93
Annunciator
Configuration
RLCD, RLCD-C,
RLED-C, RGCI
• The R-Series annunciator
configuration does not match the
actual hardware
• The R-Series expander is not
communicating with the R-Series
annunciator
xx94
Annunciator
Class A
RLCD, RLCD-C,
RLED-C, RGCI
N/A
xx95
Ann Database
Supervision
RLCD, RLCD-C,
RLED-C, RGCI
The R-Series annunciator database is
corrupt
xx96
Annunciator Code
Supervision
RLCD, RLCD-C,
RLED-C, RGCI
The R-Series annunciator database is
corrupt
[1] Up to 30 annunciators can be configured per cabinet. The first two digits in the address
column represent the annunciator number. See Table 54.