Setting Up DSL/IP Tests
350 MAX-635G
Test Setup
On-screen function buttons:
Add/Insert is available only when a blank entry is highlighted.
When the button is pressed, the first available channel from the
alias Channel List is automatically added to this list of channels.
Upon highlighting another blank entry, the next channel from the
alias table is added, and so on.
Delete removes the selected channel from the list.
You can Enable either one or both, but you cannot Disable both of them at
same time. If both tests are enabled, Join/leave Test runs first.
To configure test setup values:
1. Press the up/down arrow keys to select the desired parameter.
2. Press the left/right arrow keys to view and select the options.
OR
3. Press on a value to open a list box of options or the alphanumeric
editor screen and use the navigation keys to scroll through.
4. Press to confirm the value.
To Next Page
Loading...
