198
www.factoryfive.com 508-291-3443
If you are running EFI without emissions equipment, the vacuum/electrical solenoids located on
top of the foot box along with the vacuum reservoir on the firewall are not necessary. Plug the
vacuum outlets on the intake remove the unused parts.
Use screws provided with kit to mount the vacuum controls and BAP (Barometric Air Pressure) sensor
to the firewall.
The BAP sensor is similar to a MAP sensor used on speed density cars except it does not get
hooked up to vacuum; it is left open to the air.
Attach the computer connectors to the starter solenoid and the ground to the backside of the solenoid
against the ¾” tubing. The ground looks like a female stereo jack (sort of). The other half of the
connector is on the battery negative cable, so just cut the connector off and use the ring connector.
To Next Page
Loading...
