Fagor QC-PDS - 3.4 Status indicator LEDs

 Drives
DRIVES
Status indicator LED's
3.
Ref.2003
· 137 ·
QC-PDS
HARDWARE
3.4 Status indicator LED's
FAGOR QC-DR-  +  -FD2 dual-drives have four status indicator LEDs.
D8|D9 status leds
Configuration and error status leds.
D10|D11 status leds
Status LEDs for Ethernet communication and SERCOS-III interface.
Modes Meaning
OFF
ON
Blinking with t ON at 20 %
Blinking with t ON at 80 %
Left (led D8) / right (led D9) alternate blinking
Error
D8 D9 Meaning
Initial state.
Equipment is not
configured.
Equipment configured with
SERCOS-III communication and
without voltage in the DC BUS.
Equipment configured with
SERCOS-III communication and
voltage + DC BUS is not
Equipment configured with
SERCOS-III communication and
voltage + DC BUS is enabled.
Error status
Internal code error.
Miniboot error, non-DSP version
axis 2 configured
axis 2 not configured
axis 1 configured
axis 2 configured
axis 2 not configured
axis 1 configured
one blink per
sequence
No. of blinks =
Error group No.
burst flickering
INFORMATION.
Display the error codes on the QUERCUS CNC screen.
i
INFORMATION.
LEDs D10|D11 indicate the status of the transmission between two units
using a SERCOS-III connection. The information on these LEDs must
ONLY be interpreted on the unit connected in B10B.
i
Led Name Status Meaning
D10 LINK
ON Physical connection established
OFF No connection
D11 ACTIVITY
OFF No activity
LIT FIXED
(not blinking)
Establishing SERCOS-III communication
·active port·
Blinking
2 Hz. Software update procedure or
inactive port.
4 Hz. SERCOS-III communication
established ·active port·