Fagor QC-PDS - 7.2 Power cables. DRIVE|MOTOR connection; 7.2.1 Multi-pole cables

 Cables
7.
CABLES
Power cables. DRIVE|MOTOR connection
· 218 ·
230
Ref.2003
QC-PDS
HARDWARE
7.2 Power cables. DRIVE|MOTOR connection
7.2.1 Multi-pole cables
Without end connectors
The range of multi-pole power cables without end connectors for MPC-
4xS-  M (for brakeless motors) and MPC-4xS+(2x1)-  M (for motors with a
brake) supplied by FAGOR to establish the connection between the
motors and the QC-DR drives is provided in table T. H7/4.
These are supplied upon request and without end connectors, as the power
connector on the motor side will usually different, in general, depending on
the motor to which it will be connected. Available lengths: 5, 10, 15, 20, 30,
35, 40, 50, 75, 100, 150, 200, 250 and 300 meters for cross sections of up
to 10 mm², inclusive. For all other sections, only up to 100 m.
With an MC-20/6 connector on the motor end
The range of multi-pole power cables with MC-20/6 end connectors for
MPC-C-4xS-  M (for brakeless motors) and MPC-C-B-4xS+(2x1)-  M (for
motors with a brake) supplied by FAGOR to establish the connection
between some FKM motors and the QC-DR drives is provided in table T.
H7/5.
Available lengths in 6 m, 7 m and 8 m for 1.5 mm² and 2.5 mm² conductors.
It is supplied without end connectors (except for those referred to in the
table T. H7/5) and always upon request.
T. H7/4 Range of multi-pole power cables. Outside diameter.
· for a brakeless motor · · for a motor with a brake ·
Reference  e approx. Reference  e approx.
MPC-4x1.5-  M
9.1 mm
MPC-4x1.5+(2x1)-  M 12.5 mm
MPC-4x2.5-
 M
10.6 mm
MPC-4x2.5+(2x1)-  M 13.8 mm
MPC-4x4-
 M
11.9 mm
MPC-4x4+(2x1)-  M 14.9 mm
MPC-4x6-
 M
14.5 mm
MPC-4x6+(2x1)-  M 17.0 mm
MPC-4x10-
 M
17.5 mm
MPC-4x10+(2x1)-  M 19.9 mm
MPC-4x16-
 M
21.6 mm
MPC-4x16+(2x1.5)-  M 23.3 mm
MPC-4x25-
 M
25.2 mm
MPC-4x25+(2x1)-  M 27.0 mm
MPC-4x35-
 M
28.6 mm
MPC-4x35+(2x1)-
 M 31.4 mm
MPC-4x50-
 M
33.4 mm
MPC-4x50+(2x1.5)-  M 34.8 mm
MPC-4x70-
 M 42.5 mm
MPC-4xS, S: cross sectional area.  M: Length in m.  e approx: Approximate
outside diameter of the cable.
T. H7/5 Range of multi-pole power cables with an MC-20/6 connector on the
motor end. Outside diameter.
· for a brakeless motor · · for a motor with a brake ·
Reference  e approx. Reference  e approx.
MPC- C -4x1,5-  M 10.0 mm MPC- C - B -4x2,5+(2x1)-  M 15.3 mm
MPC- C -4x S -  M, S: cross sectional area of conductor.  M: Length in m.  e
approx.: Approximate outside diameter of the cable.
INFORMATION. With regard to the motor, it refers to motors cataloged by
FAGOR and listed in the tables under section “motor-drive matching” in
chapter 3. DRIVES of this manual.
MANDATORY. In order for the system to comply with the European
Directive on Electromagnetic Compatibility, the multi-pole cable carrying 6
or 4 cables, depending on whether the motor has a brake or not, must be
shielded and also the shield must be connected at both ends; in other
words, both at the drive end and a the motor end. This condition is a must.
i