Fagor QC-PDS - 8.5.6 Connecting the external braking resistor(s) to non-regenerative power supplies

 Installation
8.
INSTALLATION
Electrical connections
302
Ref.2003
· 270 ·
QC-PDS
HARDWARE
8.5.6 Connecting the external braking resistor(s) to non-regenerative power
supplies
The external braking resistors are designed to be connected to the X15
connector terminals on the QC-PS-
 main power supplies. These are
installed in order to dissipate any excess energy generated during the
braking of the servomotors.
Resistor model
See section, · 4.3 EXTERNAL BRAKING RESISTORS · for details on the
available external braking resistors. ALWAYS remember that at least one
must be installed.
Connection diagram
INFORMATION. Please note that, the resistor ER+TH-18/1100 can also be
installed in the bus protection module, QC-BPM-100. See section · 8.5.7
CONNECTING THE EXTERNAL BRAKING RESISTORS FOR THE QC-BPM-100 · below
for all details of the installation.
i
F. H8/25
QC-PS-  . External braking resistor(s) connection.

X15
QC-PS- 
R
R
Connect both R terminals of the braking resistor
to the aerial X15 connector and then to the X15
connector of the non-regenerative QC-PS-

power supply