Drives
DRIVES
Single-drives
3.
Ref.2003
· 101 ·
QC-PDS
HARDWARE
3.1.6 Connectors
Distribution
See section, 3.1.1 OUTSIDE APPEARANCE.
Function
X11A connector.
Motor power connection
Male 3-pin connector located on top of the drive and identified as X11A.
The following table shows the main data of the aerial plug connector
according to the drive and the conductor to be connected:
QC-DR-007-F
| QC-DR-012-F
Female aerial plug connector with screw connection with tension sleeve
and lock and release lever (automatic latching) supplied as an accessory.
They are used to connect the power to the motor. Accordingly, this
connector will be available for the indicated models to power the motor.
QC-DR-021-F
| QC-DR-030-F
Female aerial plug connector with screw connection with tension sleeve
and automatic click and lock system supplied as an accessory. They are
used to connect the power to the motor. Accordingly, this connector will be
available for the indicated models to power the motor.
NOTE. All the connectors of the unit are polarized and they can only be
connected in one position to avoid any inverted connections.
Connector data
Nr of poles 3
Gap (mm) 7.62
Min./max. tightening torque (N·m)
0.5/0.6
Flat screwdriver, size (mm)
0.6 x 3.5
Minimum section (mm²)
See table
T. H3/5
Maximum section permitted (mm²) 2.5
Maximum nominal input current (A)
6
Connection data
Length to strip (mm)
8
Connector data
Nr of poles 3
Gap (mm) 7.62
Min./max. tightening torque for S
4 mm² (N·m) 0.5/0.6
Min./max. tightening torque for S
4 mm² (N·m) 0.7/0.8
Flat screwdriver, size (mm) 0.6 x 3.5
Minimum section (mm²)
See table
T. H3/5
Maximum section permitted (mm²)
6
Maximum nominal input current (A) 23.0
Connection data
Length to strip (mm) 10
To Next Page
Loading...