Auxiliary modules
AUXILIARY MODULES
Capacitor Module
4.
Ref.2003
· 151 ·
QC-PDS
HARDWARE
4.5.3 Connectors
Distribution
Installation
If this module is installed, it can be done with the DC BUS in any position,
although it is recommended to have it located at one end.
FAGOR supplies each module with two plates for connecting the DC BUS
to the (+/-) A17 terminals.
See section, 8.4.1 PLATE CONNECTION IN THE POWER DC BUS to carry out a
proper installation. See dimensions in 11.7 CAPACITOR MODULE.
NOTE. This equipment has only A17 connection terminals to the DC
BUS. It has no other connector.
F. H4/8
QC-CM-75 capacitor module. Connector layout.
To Next Page
Loading...