Ref.2003
· 15 ·
Previous I
QC-PDS
HARDWARE
Shipment
When shipping the unit, do it protected against blows and pack it in its original cardboard box with its
original packing material. If you do not have the original packaging material, pack it as follows:
1. Get a cardboard box whose 3 inside dimensions are at least 15 cm (5.9 inches) larger than those of
the unit itself. The cardboard used to make the box must have a resistance of 170 kg (374.8 lb).
2. Attach a label indicating the owner of the unit, person to contact, type of unit and serial number.
3. In case of failure, also indicate the symptom and a short description of the failure.
4. Protect the unit wrapping it up with a roll of polyethylene or with similar material.
5. Pad the unit inside the cardboard box with polyurethane foam on all sides.
6. Seal the cardboard box with packaging tape or with industrial staples.
Storage
Store the product only under the allowed ambient conditions indicated here. Refer to this data in chapter
1, section 1.6 AMBIENT AND OPERATING CONDITIONS of this manual. Always protect the product against
dust and dirtiness.
Decommissioning and eliminating
The machine manufacturer must indicate the procedure for shutting down the machine.
Respect environmental regulations. Keep in mind that no QC-PDS servo units of the QUERCUS system
comes with a battery.
Bear in mind the storage and shipping requirements when getting rid of QC-PDS units.
Recycling
. The product is made of various materials that may be recycled and eliminated separately.
Get rid of the product in compliance with local regulations.
SHIPPING CONDITIONS, STORAGE,
DECOMMISSION AND DISPOSAL
To Next Page
Loading...