Fagor QC-PDS - 1.5 Stages of the System Configuration

 Description
38
1.
DESCRIPTION
Stages of the System Configuration
Ref.2003
· 36 ·
QC-PDS
HARDWARE
1.5 Stages of the System Configuration
The following steps are a reference to configure and install the QC-PDS
system.
Example procedure
Stage 1. Analysis of the system location
 Ambient conditions
 Mechanical conditions
 Climate conditions
 Electrical conditions
 Cooling conditions
Stage 2. Component identification
 feed axis servomotors: FKM
Spindle motors: FS5/FM7/FM9
 Power Supplies:
QC-APS-15, QC-APS3-15, QC-PS-
 , QC-RPS-  - 
 Drives: QC-DR-  ...
 Auxiliary equipment:
MAIN FILTER-  A-  , CHOKE RPS-  , QC-BPM-100, QC-CM-75,
ER+TH ...
Stage 3. Electrical cabinet configuration and connection
 Dimension diagrams
 Block diagrams
 Connection diagrams
 Power and signal cables
 Suggestions for cable installation
 Power line connection
 Electrical cabinet and ventilation
NOTE. This QC-PDS system configuration process assumes that the motors
of the system belong to the FAGOR AUTOMATION catalog. Bear in mind
that all motors listed in this FAGOR catalog are described in their
corresponding manuals:
manual of synchronous servomotors. FKM family
- man_fkm_motor.pdf -
asynchronous motor manuals. FS5 family
- man_fs5_motor.pdf -
asynchronous motor manuals. FM7/FM9 families
- man_fm7_fm9_motors.pdf -