Fagor QC-PDS - 4.6.1 Outside appearance

 Auxiliary modules
4.
AUXILIARY MODULES
External Auxiliary Power Supplies
174
Ref.2003
· 154 ·
QC-PDS
HARDWARE
4.6.1 Outside appearance
QC-APS-15
Refer to the diagram for an overall view of the outside of the unit.
F. H4/9
+24 V DC auxiliary power supply | size |0. QC-APS-15. Outside appearance.
Characteristics
plate
Version/model
label
Status indicator LED's
D1/D2/D3.
RESET button
A18.
Under cover
+24 V DC |15 A output
A18.
+24 V DC output
D7. Non-functional
A17.
(+/-) DC BUS
A17.
Under cover
(+/-) DC BUS terminals
Use this connector on A18 if the unit is installed at the far right end of the DC BUS.
Use this connector on A18 if the unit is installed at the far left end of the DC BUS.
Access lid for DC BUS
with bottom pivot hinge.
Opening and closing
click tool
A20.
L1’-L2’-L3’-FE
Three-phase
power input
M5x8 screws.
Connection for the
Protective Earth wire
PE
PE
: Protective earth.
P rotective E arth.
Tightening torque: 3 N·m
A18
FE : F unctional E arth.
Flat plate
x2
Stepped plate
x2
Clamp