Fagor QC-PDS - 1.6 Ambient and Operating Conditions

 Description
DESCRIPTION
Ambient and Operating Conditions
1.
Ref.2003
· 37 ·
QC-PDS
HARDWARE
1.6 Ambient and Operating Conditions
Terms Regulation Test reference
Mechanical specifications
Shipping
Vibration Meets:
IEC 60721-3-2
Class 2M1, sinusoidal vibration
2 Hz
 f  9 Hz, 3.5 mm amplitude
9 Hz
 f  200 Hz, 1 g
200 Hz
 f  500 Hz, 1.5 g
Jerk limit Meets:
IEC 60721-3-2
IEC 61800-2
Class 2M1,
packed unit
Operation Ambient sinusoidal
vibration tests
Meets:
CEI 60068-2-6,
Fc test
Sinusoidal vibration
10 Hz
 f  57 Hz,
constant 0.075 mm amplitude
57 Hz
 f  150 Hz,
1 g constant acceleration
Degrees of sealing
protection
(code IP)
Meets:
EN 60529
Open IP xx.
**
Always install inside
an electrical cabinet
Ambient conditions
Storage *
Ambient
temperature
Meets:
IEC 60721-3-1
IEC 61800-2
1K4,
From -25 ºC to +60 ºC
Shipping * Damp heat test
(stationary state)
Meets:
IEC 60068-2-78
IEC 61800-5-1
Disconnected power supply
40ºC +/-2ºC and
93 % +2-3 % without condensation
Ambient
temperature
Meets:
IEC 60068-2-1
IEC 61800-2
Packed
unit
-40 °C to +70 ºC
Operation
Ambient test.
Cold
Meets:
CEI 61800-2
5 ºC in running
conditions
Ambient test.
Dry heat
Meets:
IEC 60068-2-2,
Bd test
Under nominal conditions of 45 °C.
Under running conditions between
5 ºC and 55 ºC with derating (see
derating characteristic).
Damp heat test
(stationary state)
Meets:
IEC 60068-2-78
IEC 61800-5-1
Disconnected power supply. 40 ºC
+/-2 ºC
93 % +2-3 % non-condensing
Installation altitude
over average
sea level without
derating
Meets:
IEC 61800-5-1
IEC 60664-1
Pollution degree 2
and altitude of
 2000 amsl under
nominal conditions
* The shipping and storage environment must be dry and dust free.
** Open IP xx , to be installed inside a cabinet or assembly that provides the required access
protection.