Fagor QC-PDS - 2.1.5 External braking resistor selections

 Power supplies
80
2.
POWER SUPPLIES
Non-regenerative Power Supplies
· 52 ·
Ref.2003
· 52 ·
QC-PDS
HARDWARE
2.1.5 External braking resistor selections
The QC-PS-  models have, on their front side and on top of the X14
connector (see diagram), three S16 micro-switches for selecting the
installed external Ballast resistor. Use the table below to determine the
arrangement of the micro-switches based on the installed external braking
resistor model.
For the dip-switch combination shown in the figure and verified in the table,
the Ballast resistor selected would correspond to the ER+TH-18/1800.
T. H2/9 S16 micro-selector switches for the external braking resistor
connected to the power supply.
S3 S2 S1 EXTERNAL RESISTOR
OFF OFF OFF
Protection disabled
OFF OFF ON
ER+TH-18/1100
OFF ON OFF
ER+TH-18/1000+FAN
OFF ON ON
ER+TH-18/1800
ON OFF OFF
ER+TH-18/2200
ON ON OFF
Protection disabled.
ON OFF ON
ER+TH-18/1500+FAN or
ER+TH-18/2000+FAN or
NON-FAGOR external resistor
· read warning ·
ON ON ON
ER+TH-18/1500+FAN or
ER+TH-18/2000+FAN or
NON-FAGOR external resistor
· read warning ·
 represents the moving element of the mircro-switch in the figure.
WARNING. If you are installing a NON-FAGOR external resistor
and if its power is higher than any of the FAGOR resistors listed in
that same cell of the table, then select the indicated micro-
switch arrangement. Ignoring this warning MAY CAUSE THE
DESTRUCTION of the resistor WITHOUT PRIOR WARNING. If a lower
power NON-FAGOR resistor is to be installed, ensure it has its
OWN PROTECTION SYSTEM.
Example
S3 S2 S1 EXTERNAL RESISTOR
OFF ON ON
ER+TH-18/1800
ON
S1
S2
S3
S16