Functional safety
9.
FUNCTIONAL SAFETY
· 304 ·
320
Ref.2003
QC-PDS
HARDWARE
EN ISO 13849
EN ISO 13849-1
Safety of machinery - Safety-related parts of control systems - Part.1:
General principles for design.
EN ISO 13849-2
For validation purposes, the standard EN ISO 13849-2 should be used.
Technical data
The technical data on the drive required for the evaluation of the
SRP/CS of the whole machine according to standard EN ISO 13849 is
provided in T. H9/1 CALCULATION DATA ACCORDING TO EN ISO 13849-1.
Examples
See 9.4 DESIGN REQUIREMENTS
IEC/EN 62061
IEC/EN 62061
Safety of machinery - Functional safety of safety-related electrical,
electronic and programmable electronic control systems.
Use of the drives in SRECS
While the drive is not certified according to standard IEC/EN 62061, it
can be used to develop SRECS that comply with it, since the QC-DR
drive is certified according to IEC 61508 and IEC 61800-5-2.
Technical data
The technical data on the drive required for the evaluation of the
SRECS of the whole machine according to standard IEC/EN 62016 is
provided in T. H9/2 CALCULATION DATA ACCORDING TO IEC 61508 AND IEC
61800-5-2.
Identification of equipment with TÜV certificate
Models
The ·TÜV SÜD FUNCTIONAL SAFETY CERTIFICATE· list of modules ·DRIVE QC-
PDS· TÜV FS certificates. This document is provided at the beginning of
this manual.
Units
See section, 12.7 IDENTIFICATION OF EQUIPMENT.
The equipment certified with ·TÜV SÜD Functional Safety· should include
the following identification mark in the model version label, the features
label, and the packing label:
TÜV SÜD Functional Safety
To Next Page
Loading...