Installation
INSTALLATION
Electrical connections
8.
Ref.2003
· 281 ·
QC-PDS
HARDWARE
8.5.10 Connecting the - KM1 external power contactor control
QC-RPS-X-XX regenerative power supplies
The - KM1 external power contactor control is established via the KAE4
relay connected to terminals B+/ B- on the X12 connector. All
information regarding the X12 connector can be found in section, 2.2
REGENERATIVE POWER SUPPLIES, X12 CONNECTOR. - KM1 EXTERNAL POWER
CONTACTOR CONTROL.
Refer to the diagram in ANNEX A3, pages 5 and 14 of chapter 10. CONNECTION
DIAGRAMS before making the connection.
To Next Page
Loading...