Fagor QC-PDS - 8.6.6 SERCOS-II connections for the integrated FAGOR CNC 8065

 Installation
8.
INSTALLATION
Connection of the control and communications signals
302
Ref.2003
· 294 ·
QC-PDS
HARDWARE
8.6.6 SERCOS-II connections for the integrated FAGOR CNC 8065
The SERCOS-II connection between the QC-DR-275-SS2 drive (X6
connector) or the QC-RPS-160-SN0 power supply (X6 connector) to the
integrated FAGOR CNC 8065 central unit is made via the SERCOS
IN|OUT B32 SERCOS connector found on the right side of the CNC. See
figure.
For more information, refer to the manuals of the FAGOR 8060/65 CNC.
F. H8/44
B32 SERCOS connector. SERCOS-II connector for the integrated FAGOR
8065 CNC.
B32.
SERCOS
10K integrated
CNC 8065