Fagor QC-PDS - 5.1.4 Summary of the three pre-selections

 Selection criteria
SELECTING CRITERIA
Synchronous motor selection
5.
· 179 ·
Ref.2003
QC-PDS
HARDWARE
5.1.4 Summary of the three pre-selections
 Maximum speed equal to or greater than calculated value in RPM
motor
 Stall torque equal to or greater than calculate continuous value M
continuous
 Motor inertia equal to or greater than inertia J
load
/ k
 Peak torque equal to or greater than calculated value M
max.
 Rated motor torque equal to or greater than the calculated RMS value M
rms
.