Fagor QC-PDS - 8.7 Checking the installation

 Installation
INSTALLATION
Checking the installation
8.
Ref.2003
· 301 ·
QC-PDS
HARDWARE
8.7 Checking the installation
Check the installation made:
 Mechanical fixings of the entire system.
 Distances.
 Tightening all screws with the corresponding torque.
 Electrical connections and cabling.
 Connection of protection conductors.
 Fuses, value and type.
 Ends of the cable conductors.
 Properly installed cables and connectors.
 Mechanical locks of the connectors.
 Control cables.
 Shielded connections required under the EMC Directive.
 Compliance with the EMC Directive.
 Electrical cabinet covers and seals satisfactory installed in order to
achieve the degree of protection required.