Installation
INSTALLATION
Location
8.
Ref.2003
· 237 ·
QC-PDS
HARDWARE
Clamp installation
The reason for installing this clamp is to join the size |0 module with the
adjacent module in order to avoid or minimize vibrations.
Insert the clamp into one of either grooves designed for this purpose on the
upper part of both modules (the module and the adjacent module) as
shown in the figure:
NOTE. ONLY available for size|0 modules (width: 39 mm).
MANDATORY. ALWAYS use the clamp provided as an accessory for size
|0 modules.
F. H8/6
Installation of the clamp between a module size |0 and an adjacent module.
module
size |0
module to right
clamp
accessory supplied with all
equipment size |0
module
size |0
module to left
INFORMATION. No tool is required to insert the clamp into the grooves.
They are easily inserted while pressing with your fingers.
To Next Page
Loading...