Installation
8.
INSTALLATION
Connection of the control and communications signals
302
Ref.2003
· 288 ·
QC-PDS
HARDWARE
Node identification
See QUERCUS CNC in the · man_qc_60_65_inst.pdf · manual.
Transmission speed selection
See QUERCUS CNC in the · man_qc_60_65_inst.pdf · manual.
F. H8/37
Connecting the SERCOS-III BUS with a QC-RPS-
-F
regenerative power
supply.
NOTE. Note that if the machine has two separate QC-PDS systems (each
with their own power supply) and a single QUERCUS CNC, the same
SERCOS-III BUS must interconnect all the modules of both machine
systems.
QUERCUS CNC
B10
SERCOS-III CONNECTION
UPON REQUEST
QC-FBC-X 1 ... 7 m
QC-FBC-FLEX-X 10 ... 100 m
GREEN
ACCESSORY
QC-FBC-0.25
GREEN
ACCESSORY. SERCOS-IIICABLE
QC-FBC-0.25
QC-APS3-15
QC-BPM-100
QC-RPS-030-FX
Note.
For sections longer than 7 meters, use the QC-FBC-FLEX-
Ethernet cable.
QUERCUS CNC + QC-RPS-
-F
+ QC-DR-...-F
WARNING. The bending radius of the QC-FBC-
Ethernet cables must
always be greater than 30 mm and 42 mm for the QC-FBC-FLEX-
.
To Next Page
Loading...