Fagor QC-PDS - Page 48

 Power supplies
80
2.
POWER SUPPLIES
Non-regenerative Power Supplies
· 48 ·
Ref.2003
· 48 ·
QC-PDS
HARDWARE
X15 connector.
External braking resistor connections
Male 2-pin connector located under the unit and identified as X15.
Female aerial plug connector with screw connection and automatic click
and lock system supplied as an accessory. It is used to connect the
external braking resistor.
The following table shows the main data of the aerial connector and the
wire to be connected:
Pinout
Pin description
Installation
See section, 8.5.6 CONNECTING THE EXTERNAL BRAKING RESISTOR(S) TO NON-
REGENERATIVE POWER SUPPLIES.
Connector data
Nr of poles 2
Gap (mm) 7.62
Min./max. tightening torque (N·m) 0.5/0.8
Flat screwdriver, size (mm) 0.6 x 3.5
Connection data
Length to strip (mm)
10
F. H2/6
X15 connector. Pinout.
T. H2/5 X15 connector. Pin description.
Pin Signal Description
1
R
External braking resistor/s connecting terminals.
2
R
R
2
R
1
2