Fagor QC-PDS - Page 71

 Power supplies
POWER SUPPLIES
Regenerative Power Supplies
2.
Ref.2003
· 71 ·
QC-PDS
HARDWARE
B10B|B10A connectors.
Industrial 100 Mbps Ethernet. Digital SERCOS-III interface
RJ-45 connectors establish communications through a SERCOS-III digital
interface through a 100 Mbps industrial Ethernet network, with a structure
that serves an inline topology (between the QC-RPS-  -F  power supply,
the QC-DR-...-F
 drives and the QUERCUS CNC numerical control)
governing the axes. All of which are connected to the network.
The physical connection of the Ethernet bus between the power supply, if
it is regenerative, and the · single or dual · drives is made using the
following cable:
The physical connection of the Ethernet bus between the QUERCUS
CNC numerical control and one of the · single or dual · drives or a
regenerative power supply is made using the following cable:
Installation
See section, 2.2 CONNECTION TREE in the QUERCUS CNC installation
manual · man_qc_60_65_inst.pdf ·
for more information on the
identification of the modules connected to the SERCOS-III bus.
See section, INTERCONNECTION on 8.6.3 SERCOS-III CONNECTIONS.
NOTE. Only available for QC-RPS-  -F  models
F. H2/24
B10B|B10A connectors. Digital SERCOS-III interface.
SERCOS-III cable Length
QC-FBC-0.25
0.25 m
NOTE. This cable is supplied as an accessory only with each drive and
not with the regenerative power supply.
SERCOS-III cable Length
QC-SBC-   7 m
QC-SBC-FLEX-
 > 7 m
NOTE. This cable is only available upon request.