FLIR BRICKSTREAM 3D Gen 2 - Page 40

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
40
9. Select Internet Protocol Version (TCP/IPv4) and click Properties. The Internet Protocol Version 4
(TCP/IPv4) Properties window opens.
10. Take note of the current settings in this window so that you can change them back after you set
the network parameters on the sensor. If these settings are not configured to be obtained
automatically, record the initial values here:
TCP/IP Setting Initial Value on PC
IP address
Subnet mask
Default gateway
Preferred DNS server