15.1.1 Using the combined power supply and battery charger to charge
the battery when it is inside the camera
NOTE
For brevity, the ‘combined power supply and battery charger’ is called the ‘power
supply’ below.
Procedure
Follow this procedure to use the power supply to charge the battery when it is inside
the camera:
Open the battery compartment lid.1
Connect the power supply cable plug to the connector on the battery.2
Connect the power supply mains-electricity plug to a mains socket.3
Disconnect the power supply cable plug when the green light of the battery
condition indicator is continuous.
4
SEE ALSO
For information about the battery condition indicator, see section 9.4 – Battery con-
dition indicator on page 17.
46 Publ. No. 1558792 Rev. a460 – ENGLISH (EN) – July 1, 2010
15 – Handling the camera
To Next Page
Loading...
Need help?
General
