FLIR T Series User Manual

15.9 Mounting an additional infrared lens
NOTE
Do not touch the lens surface when you mount an infrared lens. If this happens, clean
the lens according to the instructions in section 22.2 – Infrared lens on page 111.
Procedure
Follow this procedure to mount an additional infrared lens:
Push the lens release button to unlock the lens cap.
10764003;a1
1
Rotate the lens cap 30° counter-clockwise (looking at the front of the lens).
10764103;a1
2
Carefully pull out the lens cap from the bayonet ring.
10764203;a1
3
Publ. No. 1558792 Rev. a460 – ENGLISH (EN) – July 1, 2010 55
15 – Handling the camera

FLIR T Series Specifications

General

Brand	FLIR
Model	T Series
Category	Thermal cameras
Language	English