FLIR T Series User Manual

19.2 Setting up measurement tools (advanced mode)
General
You can use the advanced mode to set up measurement tools. This mode allows
you to combine several tools, and to place them arbitrarily on the screen.
Procedure
Follow this procedure to set up a measurement tool using the advanced mode:
Push the Measure button.1
On the menu, select Advanced.2
Push the joystick. This will display a measurement toolbar at the bottom of
the screen.
3
Do one or more of the following:
■
To create an isotherm, select the toolbar button. This will display a
menu on which you can select the type of isotherm you want to use.
■
To create a spotmeter, select the toolbar button and push the joy-
stick.
■
To create an area, select the toolbar button and push the joystick.
4
SEE ALSO
For more information on isotherms, see section 19.4 – Setting up isotherms on
page 89.
■
■
For more information on the measurement toolbar, see section 10.2.1 – Measure-
ment toolbar on page 28.
Publ. No. 1558792 Rev. a460 – ENGLISH (EN) – July 1, 2010 87
19 – Working with measurement tools and isotherms

FLIR T Series Specifications

General

Brand	FLIR
Model	T Series
Category	Thermal cameras
Language	English