5. Press <<Single functions>>. Carry out the test like in the chapter <<Single functions>> .
<<function>>
<<F01 device ON>>
If an error was repaired, it must now be entered into the service stamps.
6. Select <<Service stamp>>.
<<data>>
<<D:02 M:02 Y:2001>>
7. Input the service date and confirm with <<Enter>>.
8. Use the cursor keys to switch to the service stamp entries. The error and work codes are listed in the
appendix.
9. After entering the entries information, switch into the menu.
<<Write coffee>>
10. Press <<Write coffee>>. The service stamp is now saved to the Flair and all previous history bits are reset to
zero.
<<Please wait>>
<<Terminal->Coffee>>
The input and output diagnosis is now finished.
Diagnostics data on chip card save
11. Insert the chip card into the Terminal3000 card reader.
12. Press <<Read coffee>>.
<<Please wait>>
<<Coffee->terminal>>
<<Terminal ready>>
<<Data loaded>>
13. Press <<Write card>> to save data to the chip card.
<<Overwrite card?>>
14. Confirm the message with <<Enter>>. If this chip card contains data still needed elsewhere, replace the
chip card with another one and repeat item 13.
Mark the card at its provided <<data>> space.
The created diagnostics data have to be integrated into the coffee machine service system
with the help of the <<Franke Animation>> application. Please read chapter <<loading of
diagnostics data into the Franke Animation>> in the operating manual of the <<Franke
Animation>> application.
To Next Page
Loading...
Need help?
General
