Factory parameter of the Flair
The <<factory parameter settings>> of the Flair can now be updated with the generated
factory parameter card (please see chapter <<generate Factory parameter card>> in the
operating manual of the <<Franke Animation>> application.
1 Switch on the terminal with <<ON/OFF>>.
<<Enter date>>
<<D:02 M:02 Y:2001>>
2 Input the date with the numeric keyboard and confirm with <<Enter>>.
<<Terminal ready>>
<<Data loaded>>
3 Insert the chip card <<Factory parameter>> into the Terminal3000 card reader.
4 Load data to the terminal with the <<Read card>>.
<<Please wait>>
<<Card->Terminal>>
<<Terminal ready>>
<<Data loaded>>
5 Select <<Write coffee>> to update data into the Flair.
<<Please wait>>
<<Terminal->Card>>
<<Terminal ready>>
<<Data loaded>>
The Flair has been updated with the factory parameters from the chip card now.
To Next Page
Loading...
Need help?
General
