Write coffee (writing parameters to the coffee machine)
All changes in the Terminal3000 are entered or are saved data on the cards will transfer
into the Flair.
User Terminal Screen Terminal
Carry out read card procedure (only
data from the chip card )
Ask for the machine type whether
approved
TERMINAL READY
PARAMETER LOADED
Write coffee key Check bit for Parameter card =
Authorization to writing
PLEASE WAIT
TERMINALèCOFFEE
Press ESC or Enter
ESC = Abort
Write parameter from memory to
device
PLEASE WAIT
TERMINALèCOFFEE
TERMINAL READY
PARAMETER LOADED
Possible mistakes:
No authorization to writing ERROR
WRONG DATA TYPE
No communication ERROR
WRITE ERROR
Wrong machine type e.g. F700 Test1 has not been
approved
F700 TEST 1
INVALID
Press Enter or ESC Text as before error TERMINAL READY
PARAMETER LOADED
Read coffee (read data from the coffee machine)
The data from the Flair are read into the Terminal3000 memory.
These data can be edited and written afterwards again into the Flair (as described in
chapter <<write parameter to coffee machine>>).
User Terminal Screen Terminal
Read coffee key Ask for the machine type whether
approved
PLEASE WAIT
COFFEE è TERMINAL
Clear memory into terminal.
Load memory data from the machine
into the terminal.
Set bit for data.
PLEASE WAIT
COFFEE è TERMINAL
TERMINAL READY
DATA LOADED
Possible mistakes:
No communication ERROR
READ ERROR
Wrong machine type e.g. F700 Test1 has not been
approved
F700 TEST 1
INVALID
Press Enter or ESC Text as before error TERMINAL READY
DATA LOADED
To Next Page
Loading...
Need help?
General
