Air conditioning
113
Controls in detail
O Only use the demisting function until
the windshield is clear again
(
e page 117).
O Only use the reheat function until the
misted up windows are clear again.
O Only use air-recirculation mode briefly,
e.g. in a tunnel. The windows could oth-
erwise mist up, because the flow of
fresh air is cut off and the air inside the
vehicle is circulated.
Air conditioning in the rear
For optimum climate control, set the tem-
perature control to the center position.
Only change the temperature in small in-
crements.
Heater
Recommendations for optimum climate
control:
O Set the temperature control to the cen-
ter position. Only change the tempera-
ture in small increments.
O Only use the demisting function until
the windshield is clear again
(e page 117).
O Only use air-recirculation mode briefly,
e.g. in a tunnel. The windows could oth-
erwise mist up, because the flow of
fresh air is cut off and the air inside the
vehicle is circulated.
Function
1 Sets the airflow (e page 116)
K Increases the airflow
I Decreases the airflow
2 Sets the temperature (e page 114)
3 K Blower speed bar graph dis-
play
4 i Activates/deactivates the
rear-compartment air conditioning
(
e page 114)
Function
1 Sets the temperature (e page 114)
z Demists the windshield
2 K Sets the airflow (e page 116)
z Demists the windshield
3 e Switches air-recirculation
mode on/off (
e page 118)
4 Sets the air distribution
(
e page 116)
s z Demists the windshield