Opening and closing
58
Controls in detail
Locking and unlocking the vehicle with
the remote control
E To unlock the driver's door: press
the % button.
The turn signals flash once. The anti-
theft alarm system (ATA) is deactivat-
ed.
E To unlock the sliding doors and the
rear doors: press the 5 button.
The turn signals flash once.
E To unlock the vehicle centrally: un-
lock the driver's door.
E Press the % button within 2 sec-
onds again.
The turn signals flash once.
i Panel van and crewbus only:
If you unlock the vehicle using the remote con-
trol with key and do not open a door within
40 seconds, the vehicle locks again automatical-
ly.
E To lock the vehicle centrally: press
the & button.
The turn signals flash three times if the
drive authorization system or the anti-
theft alarm system (ATA) is activated
and all the doors are closed
i Make sure that the locking knobs have
dropped down.
Locking and unlocking the vehicle with
the key
If the doors can no longer be locked or un-
locked with the remote control, you can
lock and unlock the driver's door and the
rear doors with the key.
Driver's door
Rear door
1 To lock
2 To unlock
E To unlock the driver's door or the
rear door: press the key release but-
ton on the remote control.
The key folds out.
E Insert the key fully into the driver's
door lock and turn it to position 2.
The door is unlocked.
i The anti-theft alarm system (ATA) is trig-
gered when you open the vehicle using the key.
The alarm can be disabled in the following
ways:
E Press the % button on the remote
control.
or
E Insert the key into the ignition lock.