freightliner Sprinter Operator's Manual

Seats
71
Controls in detail
Removing the head restraints
E Pull the head restraint up as far as it
will go.
E Press release button 1 and pull the
head restraint out.
Installing the head restraints
! Make sure that the head restraint is rein-
stalled in such a way that its front faces in the di-
rection of travel (comfort head restraint).
E Insert the head restraint so that the rod
with the notches is in the direction of
travel on the left.
E Push the head restraint down until it
engages.
E To adjust the armrest angle: fold the
armrest up by an angle of more than
45° to unlock it 2.
E Fold the armrest forward to stop 3.
E Fold the armrest up to the desired po-
sition.
E To fold up the armrest: if you do not
wish to use the armrest, fold it up by an
angle of more than 90° 1.
1 Normal heating
2 Rapid heating
E Turn the key to position 2 in the igni-
tion lock.
Normal heating
E To switch on: press the upper part of
the b switch.
One indicator lamp in the switch comes
on.
E To switch off: press the upper part of
the b switch again.
The indicator lamp in the switch goes
out.
Rapid heating
E To switch on: press the lower part of
the c switch.
Both indicator lamps in the switch
come on.
E To switch off: press the lower part of
the c switch again.
The indicator lamps in the switch go
out.
E To switch down to normal heating:
press the upper part of the b
switch.
Only one indicator lamp in the switch
remains lit.
i The rapid seat heating switches automati-
cally to normal heating mode after approximate-
ly 5 minutes.
Armrests
Seat heating

freightliner Sprinter Specifications

General

Brand	freightliner
Model	Sprinter
Category	Automobile
Language	English