freightliner Sprinter Operator's Manual

Lighting
79
Controls in detail
There is a switch on each rear interior
lamp, which can be used to switch the
lamp concerned on/off separately, re-
gardless of the position of the master con-
trol switch.
Rear interior lighting master control switch
1 To switch on the rear interior lighting
2 Automatic control
3 To switch off the rear interior lighting
E To switch on: press upper part 1 of
the switch.
The rear interior lamps are switched on
when the switches on the rear interior
lamps (
e page 78) are not in Off posi-
tion 2.
E To switch off: press lower part 3 of
the switch.
All rear interior lamps are switched off
regardless of the position of the switch
on the rear interior lamp.
Automatic control
E To switch on: set the rear interior
lighting master control switch to
position 2.
If the switch on the rear interior lamps
(e page 78) is set to automatic
control 3, the rear interior lamps
come on when you open a door or un-
lock the vehicle.
i The rear interior lamps switch off automati-
cally after 20 minutes.
If you wish to reactivate the rear interior
lamps, you must:
O open a door
O switch on the ignition again
Load compartment motion detector
On panel vans equipped with a motion de-
tector in the load compartment, the rear
interior lighting may also switch on if mo-
tion is detected.
If the motion detector detects movement
in the load compartment when the vehicle
is stationary, the rear interior lighting
switches on for approximately 2 minutes.
The rear interior lighting can be switched
on by the motion detector with a delay of
no more than 4 seconds if:
O the switch on the rear interior lamp
(
e page 78) is set to "automatic con-
trol".
O the vehicle is stationary, the handbrake
is applied and the service brake is not
applied.
or
O the selector lever is in position P and
the service brake is not applied.
O the vehicle has not been locked from
the outside using the key.
The motion detector switches off automat-
ically if no change is detected in the vehi-
cle for several hours, e.g. door opened,
ignition key turned, etc.
G Warning
Motion detectors work with invisible infrared
beams emitted by LEDs (Light Emitting Di-
odes).
Do not view invisible infrared radiation, laser
class 1M, directly using optical instruments,
e.g. glasses.
Your eyes could otherwise be injured.

freightliner Sprinter Specifications

General

Brand	freightliner
Model	Sprinter
Category	Automobile
Language	English