3-6
■ Selecting menus to display
The menu-driven system allows you to cycle through menus. To cycle through necessary menus only for simple operation, use
function code E52 that provides a choice of three display modes as listed below.
The factory default (E52 = 0) is to display only three menus--Menu #0 "Quick Setup," Menu #1 "Data Setting" and Menu #7
"Data Copying," allowing no switching to any other menu.
Table 3.5 Keypad Display Mode Selection – Function Code E52
Data for E52 Mode Menus selectable
0 Function code data editing mode (factory default)
Menu #0 "Quick Setup"
Menu #1 "Data Setting"
Menu #7 "Data Copying"
1 Function code data check mode
Menu #2 "Data Checking"
Menu #7 "Data Copying"
2 Full-menu mode Menus #0 through #7
Press the key to enter Programming mode and display menus. While cycling through the menus with the /
key, select the desired menu item with the key. Once the entire menu has been cycled through, the display returns
to the first menu item.
3.4.1 Setting up basic function codes quickly -- Menu #0 "Quick Setup" --
Menu #0 "Quick Setup" in Programming mode allows you to quickly display and set up a basic set of function codes specified
in Chapter 5, Section 5.1, "Function Code Tables."
To use Menu #0 "Quick Setup," you need to set function code E52 to "0" (Function code data editing mode) or "2" (Full-menu
mode).
The predefined set of function codes that are subject to quick setup are held in the inverter.
Figure 3.2 shows the menu transition in Menu #0 "Quick Setup" and function code data changing procedure.
Figure 3.2 Menu Transition in Menu #0 "Quick Setup" and Function Code Data Changing Procedure
To Next Page
Loading...
