3-24
3.6 USB Connectivity
The keypad has a USB port (mini B connector) on its face. To connect a USB cable, open the USB port cover as shown below.
Connecting the inverter to a PC with a USB cable enables remote control from FRENIC Loader. On the PC running FRENIC
Loader, it is possible to edit, check, manage, and monitor the function code data in real-time, to start or stop the inverter, and to
monitor the running or alarm status of the inverter.
For the instructions on how to use the FRENIC Loader, refer to the FRENIC Loader Instruction Manual.
In addition, using the keypad as a temporary storage media allows you to store the running status information in the keypad,
detach the keypad from the inverter, connect it to a PC running FRENIC Loader at an office or off-site place.
For details on how to store data into the keypad, refer to Section 3.4.8 "Copying data."
To Next Page
Loading...
