6-46
6.3.2.3 Using the card in combination with a Fuji motor
Table 6.3.3 GRK-type ES Motors
Motor type GRK2200M GRK2400M GRK2750M GRK2151A GRK2221A GRK2301A GRK2371A
FRENIC-VG model FRN0.75VG1S-2J FRN1.5VG1S-2J FRN2.2VG1S-2J FRN3.7VG1S-2J
Rated output (kW) 0.2 0.4 0.75 1.5 2.2 3.0 3.7
Rated torque (N･m) 0.955 1.91 3.58 7.16 10.5 14.3 17.7
Rated rotational speed
(r/min.)
2000
Max. rotational speed
(r/min.)
2500
Max. torque (N･m) 1.43 2.87 5.38 10.8 15.8 21.5 26.5
Rated current (A) 1.2 2.3 4.0 8.6 13.0 17.2 21.0
Max. current (A) 2.0 3.6 6.0 13.0 19.5 25.8 31.5
* Contact Fuji if you wish to use the card with a motor with a rating of less than 0.2 kW.
* Contact Fuji for more information about how to configure the FRENIC-VG with motor parameters.
* Choose the OPC-VG1-PMPGo since these motors use 1000P/R pulse encoders and open collector output.
* The encoder interface provides A-, B-, Z-, 1- (U-), 2- (V-), and 3- (W-)phase terminals, which should be connected for U, V, and
W 3-bit magnetic pole position detection. The Z-phase need not be connected.
Table 6.3.4 GRH-type ES Motors
Motor type GRH.30BG GRH.50BG GRH1.1BG GRH1.5BG GRH1.8BG GRH2.7BG
FRENIC-VG model FRN0.75VG1S-2J FRN1.5VG1S-2J FRN2.2VG1S-2J FRN3.7VG1S-2J FRN5.5VG1S-2J
Rated output (kW) 0.3 0.5 1.1 1.5 1.8 2.7
Rated torque (N･m) 0.955 1.59 3.50 4.77 6.88 10.3
Rated rotational speed
(r/min.)
3000 2500
Max. rotational speed
(r/min.)
3000 2500
Max. torque (N･m) 2.86 5.73 11.5 15.7 18.0 26.3
Rated current (A) 1.9 2.7 5.4 7.0 8.3 13
Max. current (A) 5.7 8.1 16.2 21.0 21.7 33.2
* Contact Fuji for more information about how to configure the FRENIC-VG with motor parameters.
* Choose the OPC-VG1-PMPG since these motors use 2000P/R pulse encoders and line driver output.
* The encoder interface provides A-, B-, Z-, 1- (U-), 2- (V-), and 3- (W-)phase terminals, which should be connected for U, V, and
W 3-bit magnetic pole position detection. The Z-phase need not be connected.
To Next Page
Loading...
