Fuji Electric FRENIC-VG Series - Link Edition Permission Selection

6-186
6.7.13.2 Link edition permission selection
Confirmation (reading) of function codes via CC-Link is always enabled. For changing (writing) function
codes, however, function code H29 "link function code protection" must be write-enabled (=0) in the link
edition permission mode. (It is put in "link edition permission mode" by factory default.)
Table 6.7.36
Condition Mode
Not assigned (Factory default) Link edition permission mode
When applicable terminal X is ON Link edition permission mode
Assignment status of 23: link edition
permission command [WE-LK] to
function codes E01 to E13 "X
function selection"
Assigned
When applicable terminal X is OFF Link edition no permission
mode
Table 6.7.37
H29 setting Link edition permission mode Link edition no permission mode
0  ×
1 × ×
O: Function codes (F, E, C, P, H, A, o, L, and U) are write-enabled, X: Function codes are write-disabled
Note 1: Wiring into S codes (command data, operation data, etc.) is always enabled regardless of this function.