Fuji Electric FRENIC-VG Series - Check Function; Mounting Check on Optional Cards; I;O Check

6-236
6.12.6 Check function
6.12.6.1 Mounting check on optional cards
When an optional DIO expansion card is mounted, it will be
possible to check with the keypad whether the optional DIO
expansion card is set to DIOA or DIOB.
Go to the Program Menu screen from the Operation Mode
screen and select "4. I/O CHECK". Select the screen with the UP
and DOWN keys (
and
) and check the screen
corresponding to the optional DIO expansion card.
For details, refer to the information provided in this manual on
how to operate the keypad.
As shown in the LCD screen example on the right-hand side, the corresponding number will be
highlighted () if DIOA is set.
6.12.6.2 I/O check
It is possible to check with the keypad of the inverter the digital I/O status of optional DIO expansion
cards. Go to the Program Menu screen from the Operation Mode screen and select "4. I/O CHECK."
Select the screen with the UP and DOWN keys (
and
)
and check the screen corresponding to the
optional DIO expansion card.
The number corresponding to a contact will be highlighted () if the contact is ON.
DIOA I/O status DIOB input status
DIOB output status
Ｒ□×１１ Ｃ□×１１
□×１２ □×１２
□×１３ □×１３
□×１４ □×１４
∧∨ÆＰＡＧＥ ＳＨＩＦＴ１６
Ｘ□２１□２５□２９□３３
□２２□２６□３０□３４
□２３□２７□３１□３５
□２４□２８□３２□３６
∧∨ÆＰＡＧＥ ＳＨＩＦＴ１９
□Ｙ２１ □Ｙ２５ □Ｙ２９
□Ｙ２２ □Ｙ２６ □Ｙ３０
□Ｙ２３ □Ｙ２７
□Ｙ２４ □Ｙ２８
∧∨ÆＰＡＧＥ ＳＨＩＦＴ２０
ＯＰ―Ａ：ＶＧ１－ＤＩＯＡ
ＯＰ－Ｂ：
ＯＰ－Ｃ：
∧∨ÆＰＡＧＥ ＳＨＩＦＴ ９