6-16
6.1.4.7 Installing a functional safety card
The following options can be connected to E port (CN16) on the control printed circuit board.
Installation procedure
(1) Install the functional safety card so that connector CN6 (on the back of the functional safety card)
connects to E port (CN16) on the control printed circuit board.
(2) Tighten the three included screws (a) to secure the functional safety card in place.
(3) Referring to Figures 6.1.2 and 6.1.3 "Removing the Front Cover," reverse the removal procedure to
mount the front cover.
Figure 6.1.15 Installing a Functional Safety Card
Options
OPC-VG1-SAFE
E port
a
Functional Safety Card
Control printed
circuit board
To Next Page
Loading...
