Fuji Electric FRENIC-VG Series - 6.4 T-Link Interface Card OPC-VG1-TL

6-54
6.4 T-Link Interface Card OPC-VG1-TL
6.4.1 Product overview
Use this option to control FRENIC-VG using the Fuji programmable logic
controller MICREX-SX (T-Link module).
Main Usage
Using this option, you can:
• Input signals to start or stop operation, etc.: FWD, REV, X1 - X9, X11 - X14,
RST
• Set the speed commands: 16-bit binary data
• Monitor the operation status (bit data)
Running forward, running reverse, during DC braking or pre-exciting,
inverter shutdown, braking, DC link bus voltage established, torque
limiting, output current limiting, during acceleration, during deceleration,
alarm relay output, remote/local, write error from T-link, and data writing
in progress
• Monitor motor speed; 16-bit binary data
• Monitor the operation status (word data)
(Speed command, output frequency, torque command, output current, output voltage, cumulative run
time, etc.)
• Reference and change function codes
Function code which can be changed during operation using the touch panel ⇒ Can be changed (and
checked) during operation
Function code which cannot be changed during operation using the touch panel ⇒ Cannot be changed
(but can be checked) during operation
• Monitor that the upper-level device and inverter are interoperating normally using the toggle monitor
control.
Function codes which can be accessed using this option are limited. For details, refer to "4.2 Function
Code List" in Chapter 4.