Fuji Electric FRENIC-VG Series - Installing a Digital 16-Bit Option Card; Installing an Analog Option Card

6-12
Figure 6.1.10 Installing a Digital Option
Card (Connected to A port)
Figure 6.1.11 Installing a Digital Option
Card (Connected to B port)
6.1.4.4 Installing a digital 16-bit option card
Install the digital 16-bit option card by following steps (1) and (2) in "Installation method 2 (when using
the option at the same time as a digital 16-bit option card)" in "6.1.4.2 Installing a digital 8-bit
communications option card."
6.1.4.5 Installing an analog option card
The following options ("analog option card") can be connected to A port (CN3) connector on the control
printed circuit board.
• When not using the analog option card together with
a digital 16-bit
option (OPC-VG1-SX, etc.), follow "Installation procedure 1"
below.
• When using the analog option card together with
a digital 16-bit
option (OPC-VG1-SX, etc.), follow "Installation procedure 2"
below.
⑤
⑥
④
③
①
②
Digital 16-bit
option
B port
A port
e
c
a
b
Digital 8-bit option card
Power supply
harness
Power supply
harness
c
D port
b
d
b
⑤
⑥
④
③
①
②
Digital 16-bit
option
e
a
b
Digital 8-bit option card
D port
b
d
b
CN25
Power
supply
harness
Power
supply
harness
CN24
CN12
Options
OPC-VG1-SX
OPC-VG1-ESX
OPC-VG1-UPAC
Options
OPC-VG1-FV
OPC-VG1-SN
OPC-VG1-AIO