6.5 SX Bus Interface Card
6-77
Chap. 6
CONTROL OPTIONS
6.5.3 External Dimensions
(Unit: mm)
Figure 6.5.3 Option Print Board External Dimensions
Connectors CN2, CN3
* FG terminal connection is not necessary. Do not connect it.
Refer to "6.1.4 Installing internal options (OPC-VG1-)"
before connecting the cables.
* This option print board does not include the SX bus cable
(dedicated) and terminating connector. Prepare a cable for the
bus connection distance. If the option is used at both ends of
the SX bus, connect the terminating connector to one of the
connector end. The terminating connector is supplied with the
CPU module of MICREX-SX.
Figure 6.5.4
A
2
E
6
5
D
3
B
A
2
E
6
5
D
3
B
To Next Page
Loading...
