Fuji Electric FRENIC-VG Series - Application Program Examples

6-116
6.5.11.2 Application program examples
The following explains a data transmission example using the MICREX-SX application program.
(1) Speed setting
From MICREX-SX, give commands to run forward (FWD) at 750r/min.
(Condition: Function code U11 "SX transmission format selection"= 0, H30 "Link Operation"=3,
maximum speed 1500r/min, SX bus station address: 10)
Give S06 the forward running command (FWD: ON) and S01 the speed command.
Figure 6.5.33
(2) Torque command monitor
Monitor the torque command value from MICREX-SX.
(Condition: Function code U11 "SX transmission format selection"= 0, SX bus station address: 10)
Figure 6.5.34