5-50
5.4.3.3 Operation monitor
FRENIC-VG Loader can monitor the following and save the monitored data in CSV format.
1 I/O monitor: This monitors the ON/OFF states of the input and output terminals of the
inverter.
2 System monitor: This shows the inverter ROM version, inverter type, current setup information,
and maintenance information of the inverter.
3 Alarm monitor: This shows the alarm status of the inverter--the current alarm content and the
various running information applied when an alarm has occurred.
This also shows a list of alarm data selected from four alarms (latest and las
three alarms).
This requires a backup battery. (Inverters of 30 kW or above: Battery included
as standard)
Refer to Chapter 8, Section 8.6 "Battery" in the FRENIC-VG User's
Manual (Unit Type / Function Codes Edition).
Figure 5.4.3-3 Operation Monitor (Alarm monitor)
On the monitor screen also, it is
possible to:
- Reset alarms
- Initialize alarm history
A list of alarm data is selectable from the
latest and the last three alarms.
To Next Page
Loading...
