Fuji Electric FRENIC-VG Series - Installing a Control Circuit Terminal Option

6.1 Common Specifications
6-17
Chap. 6
CONTROL OPTIONS
6.1.4.8 Installing a control circuit terminal option
The following options can be connected to F port (CN1) on the control printed circuit board.
 Installation procedure
(1) Loosen two screws (a) on the standard control circuit terminal printed circuit board and remove the
board from F port (CN1) on the control printed circuit board.
(2) Mount the control circuit terminal option.
(3) Tighten two screws (b) to secure the control circuit terminal option in place.
(4) Referring to Figures 6.1.2 and 6.1.3 "Removing the Front Cover," reverse the removal procedure to
mount the front cover.
Figure 6.1.16 Removing the Control Circuit
Terminal Printed Circuit Board
Figure 6.1.17 Mounting the Control Circuit
Terminal Option
Options
OPC-VG1-TBSI
a
Control circuit
terminal
printed circuit
board
Control printed
circuit board
Control circuit
terminal option
b
Control printed
circuit board
F port
F port