Fuji Electric FRENIC-VG Series - Function Codes

6-242
6.13.4 Function codes
• A dangerous condition may result if a mistake is made in function code data. Check the data again after the
data is set and entered.
Otherwise, an accident could occur.
• The keypad will not display any optional function codes of the optional AIO expansion card (i.e., E51, E52,
E55, E56, E59, E60, E63, E64, E67, E68, E72, E73, E77, E78, E82, E83, E103, E104, E107, or E108) unless
the optional AIO expansion card is mounted. These optional function codes will be displayed only after the
optional expansion card is mounted.
Function codes E51, E52, E55, E56, E59, E60, E63, E64, E67, E68, E72, E73, E77, E78, E82, E83, E103,
E104, E107, and E108 will be operable with this optional expansion card mounted.
The keypad will display these function codes with the optional AIO expansion card mounted. Otherwise,
the keypad will not display the functions.
Table 6.13.3
Parameter name
No.
Name Keypad display
Setting range Description
E51 Ai3 function selection Ai3 FUNC 0-27
E52 Ai4 function selection Ai4 FUNC 0-27
E55 Ai3 gain setting GAIN Ai3 -10.000-10.000 (times)
E56 Ai4 gain setting GAIN Ai4 -10.000-10.000 (times)
E59 Ai3 bias setting BIAS Ai3 -100.0-100.0(%)
E60 Ai4 bias setting BIAS Ai4 -100.0-100.0(%)
E63 Ai3 filter setting FILTER Ai3 0.000-0.500(s)
E64 Ai4 filter setting FILTER Ai4 0.000-0.500(s)
E67
Increment/decrement
limiter (Ai3)
A/D-L-Ai3 0.00-60.00(s)
E68
Increment/decrement
limiter (Ai4)
A/D-L-Ai4 0.00-60.00(s)
E72 AO4 function selection AO4 FUNC 0-40
E73 AO5 function selection AO5 FUNC 0-40
E77 AO4 gain setting GAIN AO4 -100.00-100.00 (times)
E78 AO5 gain setting GAIN AO5 -100.00-100.00 (times)
E82 AO4 bias setting BIAS AO4 -100.0-100.0(%)
E83 AO5 bias setting BIAS AO5 -100.0-100.0(%)
E84 AO1-5 filter setting FILT AO1-5 0.000-0.500(s)
E103 Ai3 offset Ai3 OFSET -100.00-100.00(%)
E104 Ai4 offset Ai4 OFSET -100.00-100.00(%)
E107 Ai3 dead zone Ai3 BLIND 0.00-10.00(%)
E108 Ai4 dead zone Ai4 BLIND 0.00-10.00(%)
See Chapter 4.