Fuji Electric FRENIC-VG Series - Function Codes; DIOA Selected

6-234
6.12.5 Function codes
• A dangerous condition may result if a mistake is made in function code data. Check the data again after the
data is set and entered.
Otherwise, an accident could occur.
6.12.5.1 DIOA selected
(1) Input
The following functions can be set freely to four digital input pins (X11 to X14).
The functions are set with functions codes E10 - E13.
For the X terminal functions, refer to Chapter 4, E01 to E13 (X Terminal Function).
(2) Output
The following functions can be set freely to eight digital output pins (Y11 to Y18).
The functions are set with functions codes E20 - E27.
For the Y terminal functions, refer to Chapter 4, E15 to E27 (Y Terminal Function).
Function Codes
The following function codes are used to allocate I/O functions.
Table 6.12.6
Parameter name
No.
Name Keypad display
Setting range Description
E10 X11 function selection X11 FUNC 0-76
E11 X12 function selection X12 FUNC 0-76
E12 X13 function selection X13 FUNC 0-76
E13 X14 function selection X14 FUNC 0-76
See Chapter 4
E20 Y11 function selection Y11 FUNC 0-81
E21 Y12 function selection Y12 FUNC 0-81
E22 Y13 function selection Y13 FUNC 0-81
E23 Y14 function selection Y14 FUNC 0-81
E24 Y15 function selection Y15 FUNC 0-81
E25 Y16 function selection Y16 FUNC 0-81
E26 Y17 function selection Y17 FUNC 0-81
E27 Y18 function selection Y18 FUNC 0-81
See Chapter 4